Cleaning & Maintenance; Troubleshooting - Pitco Frialator SG14 Manual De Instalación Y Operación

CLEANING / MAINTENANCE:
DAILY CLEANING:
Using a soft cloth and a mild detergent, wipe all external surfaces until they are free of debris. It is permissible to
allow a thin film of cooking oil to remain on all exposed surfaces. Be sure to clean the front panel and behind the
door.
The fryer must be properly restrained to prevent movement or tipping. This restraint must prevent the fryer
from movements that would splash hot liquids on personnel, which could cause severe burns or injuries.
Always wear oil proof gloves when moving or handling equipment or hot liquids.
WEEKLY CLEANING:
Turn the gas valve knob to the PILOT position. The fryer should be completely drained of shortening. Fill the fry
tank with water to above the minimum and below the maximum level lines. (For best results use Pitco Fryer Cleaner
Part Number P6071397.) Turn the fryer ON as described in the " R UNNING THE FRYER UP TO THE OPERATING
TEMPERATURE:" section. When the water boils, use a pair of insulated rub ber gloves and the supplied cleaning
brush to scrub the inside of the fry tank, taking care not to damage the thin capillary tubes inside the tank. When
the fryer is clean, shut the fr y er down as described in the "SHUTTING THE FRYERS DOWN FOR A SHORT
PERIOD:"section. Drain the water into a container that is capable of withstanding 400
the tank with fresh water and dry with a soft cloth until all of the water is gone. This is a good time to perform the
DAILY CLEANING. The fryer is now ready to be re filled and used.

TROUBLESHOOTING:

FRYING SYSTEM:
Should there be a prob lem with your machine, the following checks should be done pr ior to calling an Authorized
Service Company. Make sure the machine is operated correctly and that the Computer or Digital Display (when
installed) is programmed accordingly.
Check these items before calling your Authorized Service Company
ITEM TO CHECK
Power to machine
Hi-Limit reset
Power switch on
Gas to machine
Gas valve knob position
Fuses
Check pilot
Locate the problem in the chart below then follow the instructions in the above chart.
WARNING
HOW TO CHECK
Check main power to machine (When applicable.)
Press Hi-Limit reset button. Mounted on cabinet side
behind door
Power switch should be in the ON position. (On RPB
machines ONLY the manual reset switch must be
pressed after there has been an interruption in power.)
Make sure gas supply line is connected
Should be in the appropriate position
Check for blown fuses. (Where applicable.)
Make sure the pilot is lit
5
F oil. Rinse the inside of
o