SNOWJOE SUNJOE 24V-300WI Manual Del Operador página 8

m
WARNING!
Do not use any attachments or accessories
not recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can
result in serious personal injury.
m
WARNING!
Do not modify or attempt to repair the
power station except indicated in the instructions for use and
care.
m
WARNING!
This device is not intended for use in a
commercial repair facility.
m
WARNING!
The device shall be stored indoors. The unit
shall not be charged outdoors. When in use, cautions should
be taken to reduce the exposure to rain, sleet, and snow.
Intended Using
This power station can discharge connected batteries to
supply electrical power for operating compatible small
electronics and USB-powered devices such as cell phones,
tablets, laptops, LED lights, small fans, radios, etc. This device
is not compatible for use with appliances, power tools, air
conditioners, sump pumps, compressors, and/or other larger
electrical devices.
This power station is equipped with built-in charger, which can
charge up to 4 Snow Joe + Sun Joe
®
battery packs when used with the included iON+ 24V lithium-
ion battery charger.
NOTE: The charge process and the discharge process
(including powering/charging connected appliances, reading
light, spotlight, wireless charging) cannot happen at the same
time. Only one function can be used at a time.
LCD Screen (Fig. 1)
Fig. 1
Battery Battery capacity
charging indicator/Timer
status
Working
battery status
iON+ 24V lithium-iON
®
Wireless
charging status
Output power indicator
USB working status
1. Battery charging status – The icon indicate the
remaining capacity of the currently working batteries.
When battery pack(s) is/are being charged in the power
station, the icon will lit and flash to indicate the charging
process.
2. Battery capacity indicator/Timer – Indicates the
remaining capacity of the working batteries in percentage
format. When there's only one battery connected, it
will act as a timer to indicate the remaining time of
discharging process.
3. Wireless charging status – The wireless charger icon will
lit when the wireless charger on top of the power station
is working.
4. USB working status – The USB icon will lit when there is
current output from any USB receptacles.
5. Output power indicator – indicate the actual output
power when the power station is in discharging mode (A
device is connected with any receptacle or being charged
by the wireless charger).
6. Working battery status – The four icons correspond
with each battery compartment on the power station
to represent the batteries in the compartments. The
corresponding icon(s) will lit when there's battery pack(s)
in the compartment(s) ready for discharging and will flash
when the corresponding battery pack is discharging.
NOTE: The working battery status indicator will not lit up
when battery pack(s) is/are being charged or is/are flat.
7. Error display. Check the table below for each error code
and the corresponding cause and solution.
Display
F1
Indicates battery pack(s) is/are flat.
The power Charge the battery pack(s) and restart the
station will power station. If the situation continues,
automatically
call the Snow Joe
shut down.
service center at 1-866-SNOWJOE
(1-866-766-9563).
F2
The power
Indicates the power station is overheated.
station will
Wait for the power station to cool down
automatically
and restart.
shut down.
F3
The power station may be overloaded.
The power Wait for one minute and try restart the
station will power station. If the situation continues,
automatically remove some connected appliances and
shut down.
restart. If the situation continues, call the
Snow Joe
center at 1-866-SNOWJOE
(1-866-766-9563).
If any other situation happened, Please call the Snow Joe
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563).
8
Possible causes and solution
+ Sun Joe customer
® ®
+ Sun Joe customer service
® ®
+
®