Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Switching the LED light on and off
Turn on/off the LED light by Switch K.
Cutting Operations
Make sure that the Switch is in the
off-position, then plug in the tool.
Secure your workpiece to a workbench
or other solid surface.
Make sure the cord is out of the way.
Set the Guide Bar against the workpiece,
keeping blade at a 90° angle compared to
the workpiece.
Turn on the Band saw and allow it to come
up to full speed before starting the cut.
Adjust speed by turning the speed dial E.
Tilt the unit so that the blade is vertical as
shown in. To start a cut, use minimal force
to start a groove. Once groove is started,
allow the rest of the blade to cut into
workpiece. Doing this will prevent blade
from moving from side-to-side during
cutting.
CAUTION! Do not apply force to
the tool by pressing too hard
with your hands or leaning into it.
The weight of the tool itself creates
enough force to make a clean cut. Forcing
or leaning on the tool may twist or break
the blade, damaging the saw and possi-
bly causing injury. As you reach the end
of your workpiece, finish off the cut by
slightly raising the unit slowly, bringing
the blade up.
SYMBOLS
On the product, the rating label and within these instructions you will find among
others the following symbols and abbreviations. Familiarize yourself with them to
reduce hazards like personal injuries and damage to property.
V~
Volt, (alternating voltage)
Hz
Hertz
W
Watt
/min or min
Per minute
mm
Milimeter
kg
Kilogram
Note / remark
MAINTENANCE / SERVICE
• Protect the tool from impact, shock and
grease
• Always keep tool and cord clean
(especially ventilation slots I)
! disconnect the plug before cleaning
! do not attempt to clean ventilation
slots by inserting pointed objects
through openings
ENVIRONMENT
• Do not dispose of electric tools,
accessories and packaging together
with household waste material (only for
EU countries)
- in observance of European Directive
on waste of electric and electronic
equipment and its implementation in
accordance with national law, electric
tools that have reached the end of
their life must be collected separately
and returned to an environmentally
compatible recycling facility
dB(A)
Decibel (A-rated)
m/s
2
Meter per seconds
squared
Lock / to tighten or secure
Unlock / to loosen
Wear hearing protection
Publicidad
