Installation - Tecnolec TLL 510 Manual De Instrucciones

GB

INSTALLATION

Unpacking
All transit bolts at the rear of the appliance and packing must be
removed before using the appliance.
Keep all packaging away from children.
Keep all the transit bolts for re-use in case the appliance is to be
transported again.
Positioning
Install the appliance on a flat hard floor.
Make sure that there is sufficient
Do not install the appliance on the carpet floor.
Levelling
Level the appliance by raising or lowering the feet.
Loosen the lock nut using a spanner (not supplied) and turn the foot by
hand until it contacts the floor.
Hold the foot with one hand and fasten the nut against the cabinet
with a spanner.
Never put cartons, wooden blocks or similar materials under
the machine to balance the irregularities on the level of the
ground.
Accurate levelling prevents vibration, noise and displacement of the
appliance during operation.
Electrical connection
Your washing machine works with 220‐240V and 50Hz.
Electrical connections must be carried out by a qualified technician in compliance
with the current safety regulations.
Your washing machine must be properly earthed. We will not be held responsible for
any damage that may occur as a result of usage without correct earth connection.
Do not use extension leads or multi‐sockets.
Water inlet
Screw one end of the inlet hose on the back of the appliance.
The appliance must be connected to a cold water supply.
Connect the other end of the inlet hose to a tap with a 3/4" thread.
Make sure that the water inlet hose is not twisted or blocked.
Water drainage
To plumb in the appliance, please use one of the following methods.
1.Push the hose firmly into a drainage standpipe.
OR
2. Connect the drain hose onto a sink outlet spigot securely.
Notes:
Make sure that the water discharge hose does not bend, buckle, is not crushed or extended.
The water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from
the ground.
space for air circulation around the appliance.
24