Wieland SP-COP1 Manual Del Usuario página 10

4. Slide the latching foot against the standard rail with a screw-
driver until the latching foot snaps into place with an audible
CLICK.
5. Make sure that the module is firmly mounted onto the standard
rail. Try to remove the module from the standard rail with a little
pressure. If the module remains firmly connected to the rail after
this test, the mounting is correct.
6. If multiple modules are mounted:
Slide the individual modules together in the direction of the ar-
row until the lateral connector between the modules audibly
snaps into place.
Install an end terminal on the leftmost module and the rightmost
module.
4.1.3 After mounting
After mounting the modules, the following steps are required:
 Electrically connect the modules.
 Configure the modules.
 Check installation before initial commissioning.
4.2 Steps of demounting of the modules
4.2.1 Demounting of controller module
1. Remove the plug-in block terminals with the wiring and the end
terminals.
2. Slide the modules apart separately in the direction of the arrow
until the lateral connector is disconnected.
3. Unlock the module. To do so, pull the module's latching foot
outwards with a screwdriver.
10
4. Swivel the module away from the standard rail.
4.2.2 Demounting of extension modules
1. Remove the plug-in block terminals with the wiring and the end
terminals.
2. Slide the modules apart separately in the direction of the arrow
until the lateral connector is disconnected.
3. Unlock the module. To do so, pull the module's latching foot
outwards with a screwdriver.
4. Swivel the module away from the standard rail.