Stryker 1288010000 Manual Del Usuario página 25

P (Picture) Button
The P button controls up to two remote video accessories.
• Press the P button for less than two seconds to select Remote 1. One beep will sound.
• Press the P button for more than two seconds to select Remote 2. Two beeps will sound.
W (White Balance) Button
The W button activates the white-balance function or the light/zoom function. The white balance
function is used to correct slight color differences that exist between different light sources or
endoscopes.
• Press the W button for more than two seconds to activate the white balance function.
• Press the W button for less than two seconds to increase the light or zoom level. The camera
console can be set to "light" mode or "zoom" mode using the Buttons submenu of the
Configuration Menu. In "zoom" mode, each W button press will raise the light level in eight
steps. In "light" mode, each press will raise the zoom level in eight steps. When either mode has
reached its maximum, pressing the W button again will cycle the level back to the lowest setting.
Perform the white balance procedure before every surgical procedure.
Note:
Ensure that a scope and light source are attached to the camera, and that the camera, light
source and monitor are powered on before adjusting the white balance.
1. Point the scope at several stacked 4 × 4 white gauze pads, a white laparoscopic sponge, or any
clean white surface.
2. Look at the monitor and make sure that no glare is visible off of the white surface.
3. Press and hold the W button until "WHITE BALANCE IN PROGRESS" begins flashing on the
video monitor.
4. Continue pointing the scope at the white surface until the video monitor indicates that white
balance is "WHITE BALANCE COMPLETE. " The video picture may change color. If you cannot
achieve an acceptable white balance, refer to the "Troubleshooting" section of this manual.
21