Protecting The Environment - DeWalt DW755 Traducido De Las Instrucciones Originales

Ocultar thumbs

Contenido

página de 96

/ 96
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Proper Hand Position (Fig. P)

WARNING: To reduce the risk of serious personal injury,

ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal

injury, ALWAYS hold securely in anticipation of a

sudden reaction.

Refer to Figure P for proper body stance and hand positioning

when grinding and honing.

Switching On and Off (Fig. A)

To turn the tool on, set the on/off switch

To turn the tool off, set the on/off switch

Using the Grinding Wheel (Fig. A)

In order to achieve a straight cutting edge, move it slowly

backwards and forwards over the grinding wheel

a light pressure.

Using the Clamping and Grinding

Attachment (Fig. N)

1. Insert the workpiece into the clamping bracket

2. Position the workpiece as required to obtain the correct

bevel angle. The angle is a function of the protruding length

X (see Figure). For plane irons, X should be approx. 20 mm,

for chisels approx. 25–28 mm.

3. Tighten the star knobs

Using the Grinding or Honing Belt (Fig. O)

•

Hold the cutting edge of the workpiece in the direction of

rotation as indicated by the arrow

•

Move the workpiece backwards and forwards over the belt.

•

Grinding can be done at three different points on the

grinding or honing belt

Use the area a over the large belt pulley

or the area B over the backing plate

preliminary grinding.

Use the unsupported area C for finishing, as it will mould

itself to the shape of the workpiece.

Using the Water Supply System(Fig. M)

1. Unscrew the cap

2. Adjust the water flow as required using the flow

regulator

WARNING: Depending on the workpiece material, the

water may be contaminated. Keep out of reach of children.

WARNING: When the water collector is full, it must be

emptied. Dispose of the water in an environmentally

safe way.

to position 1.

to position 0.

. Only exert

on the machine.

for

MAINTENANCE

Your D

WALT power tool has been designed to operate

over a long period of time with a minimum of maintenance.

Continuous satisfactory operation depends upon proper tool

care and regular cleaning.

WARNING: To reduce the risk of serious personal

injury, turn tool off and disconnect tool from power

source before making any adjustments or removing/

installing attachments or accessories. Be sure the

trigger switch is in the OFF position. An accidental start-up

can cause injury.

On a weekly basis, remove grindings from the housing and

the covers.

Putting the Machine Out of Operation

If the machine is put out of use for a longer period of time,

remove the honing belt from the machine and store it in a dry

and safe place.

To remove the belt, refer to the instructions for Changing the

Grinding or Honing Belt.

Lubrication

Your power tool requires no additional lubrication.

Cleaning

WARNING: Blow dirt and dust out of the main housing

with dry air as often as dirt is seen collecting in and around

the air vents. Wear approved eye protection and approved

dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals

for cleaning the non-metallic parts of the tool. These

chemicals may weaken the materials used in these parts.

Use a cloth dampened only with water and mild soap.

Never let any liquid get inside the tool; never immerse any

part of the tool into a liquid.

Keep the ventilation slots clear and regularly clean the housing

with a soft cloth.

Optional Accessories

WARNING: Since accessories, other than those offered

by D

WALT, have not been tested with this product, use

of such accessories with this tool could be hazardous.

To reduce the risk of injury, only D

accessories should be used with this product.

Consult your dealer for further information on the

appropriate accessories.