Publicidad
3.4
3.5
3 sec
4. Optimizing
4.1
4.2
6
3.4 Place headset in base unit
charge cradle and charge a
minimum of 30 min. before use.
A full charge takes about 2 hours.
Visual indicator on headset will
fl ash green while headset is
charging, and light steady green
when fully charged.
3.5 Turn on headset by pressing
Hook button for 3 sec. (visual
indicator will light green for 3
sec.), or by placing headset in
base. Turn off by pressing Hook
button for 3 sec. (visual indicator
will light red for 3 sec.).
Clearest dial tone
4.1 Put on headset.
4.2 Lift handset from telephone
and listen for a dial tone in
headset.
4.3
4.4
4.5
4.6
4.7
4.8
Note: If echo is heard transmit volume is probably too high.
1)
4.3 If dial tone is missing or
unclear, slide the Clear dial tone
switch on bottom of base unit
through the 3 settings.
4.4 Set switch to the position that
gives the clearest dial tone.
Setting transmit (TX)
volume
4.5 Make a call (see section 5) to
someone who can act as a test
person.
4.6 Adjust outgoing volume with
Transmit (TX) volume control on
base unit. Switch through the 3
settings until test person confi rms
1)
the appropriate volume.
Setting incoming volume
4.7 During a call, adjust incoming
volume by pressing Volume button
on headset.
4.8 A tone in headset will
indicate when min./max. volume is
reached.
7
Publicidad
