Wall Mounting With Housing (Optional) - MR TAPCON 230 Instructions De Montage

®
30 TAPCON 230
3. Secure the device using the tension clamps.
Figure 15: Securing device
ð The device is mounted and can be wired up.

6.3.2 Wall mounting with housing (optional)

For wall mounting, the device is fixed to the wall in a housing. The housing is
an optional accessory.
Drill 4 holes, each 5.5 mm in diameter, in the wall as shown in the drilling
template below.
Figure 16: Drilling template for wall mounting
ü Close the device door.
The screws for wall mounting are not included in the scope of supply. The
screw length required depends on the wall thickness.
7820658/01 EN
6 Mounting
Maschinenfabrik Reinhausen GmbH 2021