Kohler K-2083 Guia De Instalacion página 4

Preparation (cont.)
NOTE: The supply stop handles can not extend more than 4-3/4"
(12.1 cm) from the finished wall when in the fully open position.
Install the water supplies and drain piping according to the
roughing-in information. Install the supply stops so the handles
will not touch the pedestal when fully open.
Install sufficient backing behind the finished wall to provide a
secure material for the anchoring devices.
NOTE: Ensure that the hanger is level and is secured to the backing
material behind the finished wall.
NOTE: Ensure that the spring clips are between the hanger and the
finished wall before tightening.
Using 1/4" (6 mm) lag bolts or equivalent (not provided), install
the hanger, spring clips, and angle bracket to the wall according
to the roughing-in information.
Carefully lift the lavatory into place on the hanger, and level. You
may need to raise or lower the hanger so the lavatory contacts
the wall evenly.
NOTE: The lavatory must be supported by the hanger.
Locate the two lavatory anchoring holes, and mark the hole
locations on the finished wall.
Carefully remove the lavatory from the area.
1010431-2-B 4 Kohler Co.