RBM 1219 Instrucciones Del Producto página 4

MANIFOLD KIT INSTALLATION SCHEME FOR UNDERFLOOR /
CEILING HEATING SYSTEM AND FUNCTION "MEMORY-
The operations described in this instruction document have to be carried out only by technical staff or by an
installer, respecting the security norms and the requirements of the existing law.
RIGHT installation of manifolds
with lock shields with incorporate flow meters.
Function "Memory-Stop" Flowmeter
Locking system of the degree of opening of the flow meter, allowing at the re-
opening of the circuit, the lock of the stroke at the exact position of initial setting
(project value).
1) Set the regulation of the flow meter to the project value. The white handwheel has
to be removed during this operation;
2) Screw the ring of "Memory-Stop" counter-clockwise (left thread) until you reach
the stop stroke;
3) Replace the white handwheel. Operating on the handwheel (clockwise), you can
close the single circuit. Turning on the opposite direction until its locking, you can
open the circuit, until the setting of the project value.
Through the two holes on the handwheel, you can plunge the flow meter, in order to
avoid the tampering of the setting adjustment.
Warning: DO NOT use tools for operation / adjustment of the flow meter, in order to
undermine the correct working of it.

Please refer to the technical data sheet for further information. please respect the installation, use and maintenance
instructions attached to the components supplied.
For technical characteristics please refer to what shown on our website:
RBM reserves the right to improve and change the products described as well as their relating technical information at any moment and
without previous notice; for this purpose always refer to the instructions supplied with the components and use this technical sheet in
case the information supplied are too concise. In case of doubt or for further information please call our engineering department that is
always at the customer disposal.
Instructions for RBM product IP2028.0-EN_02
STOP" FLOWMETER
OK
RBM Spa
Via S.Giuseppe, 1 - 25075 Nave (Brescia) Italy
Tel. 030-2537211 Fax 030-2531798
E-mail: info@rbm.eu –www.rbm.eu
The manifold provided with lock shield with
incorporated flow meter, must always be located
on the supply line of the connected hydraulic
system. A wrong positioning of the manifold
creates a malfunction of the system, that means a
non functionality of the flow meters, that must
absolutely work in suction.
This rule is valid both for the brass manifolds and
for the polymer ones.
Ring
"Memory-Stop"
www.rbm.eu
RBM
White cap
EN
Page 1 of 3