Publicidad
Idiomas disponibles
Idiomas disponibles
44068MEE Rev4_9225 47507 MEE pump - Jon 18/10/2010 13:12 Page 4
If the socket outlets in your home are not suitable for the plug
supplied with this appliance the plug should be removed and
the appropriate one fitted.
Where used, should the fuse in the 13 amp plug require
changing, a 13 amp BS1362 fuse must be fitted.
⁄ Bread slots
¤ Bread carriage lever(s) with high lift feature
‹ Frozen button
› Reheat button
fi Cancel button or Pause and check/Cancel button
(Depends upon model)
fl Electronic variable browning control(s)
‡ Removable crumb tray(s) at rear
· Cord storage
Frozen button
Re-heat button
Cancel button
(Depends upon model)
Pause and check/Cancel button
(Depends upon model)
•
The bread carriage levers will not stay down unless the toaster
is connected to the mains supply.
•
Before using the toaster for the first time operate the toaster
without bread.
•
As with all new electric heating elements, your toaster emits a
'new' smell when it is first switched on. This is quite normal
and not a cause for concern.
•
On the four slice models, the toaster has two sides with
controls repeated for each half. Each half can be used together
or independently.
Select the desired level of browning on the browning control
dial fl.
After selecting the desired level, place your bread in the slots
⁄ and depress the bread carriage lever downwards until it
locks.
After the set time has been reached the bread will pop up
automatically ready for removal from the slots. The bread
carriage lever will have returned to its upper position and the
heating element will have switched off.
4
If your toast has popped up and gone cold, the toaster offers a
re-heat facility. To use, depress the relevant bread carriage
lever and press the re-heat button › immediately. The button
will illuminate and the toaster will operate for a short period re-
heating the bread.
To toast frozen bread do not adjust the browning control from
your normal setting. Place the bread in the bread slots as
normal, and press the frozen button ‹.
(Depends upon model)
If you wish to interrupt the toasting process, press the cancel
button fi.
(Depends upon model)
If you wish to check the process of the toasting cycle, press
the Pause and check/cancel button fi. On pressing the
button, the bread carriage will pop up automatically for you to
check. This action will pause the heating elements, during this
period the function button lights will flash. If you have
achieved the desired level of browning remove the toast from
the toaster. If longer toasting is required, depress the bread
carriage lever within five seconds to resume the toasting
cycle at the same stage it was at when it was paused.
•
In order to achieve uniform browning, we recommend you wait
a minimum of 30 seconds between each toasting, so that the
control can be automatically reset.
•
If toasting one slice only, you may need to adjust the browning
control to a slightly lower setting.
•
Note you will also notice a slight variation in toast colour on one
side of a single slice.
•
Stale bread toasts more rapidly than fresh bread. Therefore, the
browning control should be set at a lower setting than usual.
•
All sorts of bread can be used as well as teacakes, small rolls
etc. Slices should not however be so thick as to cause burning
or jamming within the bread slots.
•
If the bread in your toaster becomes jammed disconnect your
toaster at the socket, allow it to cool, then remove the bread.
•
When toasting 2 or more slices it is recommended they are of
equal size and freshness.
•
Allow the toaster to cool fully before putting away.
Publicidad
