Publicidad
Idiomas disponibles
Idiomas disponibles
Set up an electrical multi-duct conduit in the middle of the foundation of the barrier,
corresponding to the central hole (corrugated - diameter 25 - 50mm).
INSTALLATION WITH BASE PLATE
(OPTIONAL)
Take the floor plate and bend the brackets
as needed. Dig a suitably sized hole in the
ground. Insert the electrical conduit into the
cable conduit hole of the floor plate. Level
and cement the floor plate.
Place the barrier on the floor plate and
fasten it with the self-locking M12 nuts
supplied.
INSTALLATION WITHOUT BASE PLATE
Place the barrier and block it through the
four holes present internally on the basis.
MANUAL OPENING
Open the cover with the key.
insert unlocking key and turn clockwise as in the picture below.
Please note that when the cover is opened the operator goes into block
INSTALLATION
Nuts
Brackets
Cable conduit
hole
Base plate
OPTIONAL
3
1
2
Fixing holes
4
Publicidad
