Sterilisation Of Feeding Bottles, Teats And Accessories; General Information On Sterilising; Sterilisation - NUK Vapo Rapid Instrucciones De Operación

Vapo Rapid 09-2014 Seite 16 Mittwoch, 24. September 2014 6:05 18
4. Sterilisation of feeding bottles, teats
4.1 General information on
sterilising
Newborn babies do not initially have
sufficient antibodies to be able to protect
themselves from pathogenic germs.
For this reason it is vital that sterilised teats
and bottles are used when preparing infant
feeds.
Even tiny feed residues left on teats and
bottles can easily
contamination (microbial growth).
The steam steriliser uses heat to sterilise
the components. Water is converted into
steam. The humid heat generated therefore
sterilises the components
steriliser swiftly and reliably. This way the
teats and feeding bottles only come into
contact with hot steam.
As the steam steriliser uses very little water,
only minimal power is required too.

4.2 Sterilisation

Beware! All component
sterilised must be washed thoroughly and
be free of any food residues.
The drawings A to I for the sterilisation
process can be found on the unfolded
page.
1. Remove the measuring jug
base 6 (Fig. A).
2. Using the jug measure 70ml of tap
10
water and pour into the base 6 (Fig. A).
70 ml corresponds to two beakers
N.B.:
full of water (2x 35ml).
3. Place the steam receptacle 5 on the
base 6 (Fig. B).
4. Place the bottle holder 4 in the steam
receptacle (Fig. C).
Always sterilise the bottles open
Beware!
and dismantled, otherwise the material can
become distorted.
and accessories
lead to bacterial
inside the
parts being
from the
10
16
5. Place the open bottles in the holder 4
(Fig. D).
Stack the lids if possible in the
N.B.:
holder 4. This will save space in the
accessories basket (Fig. E).
6. Place the accessories basket 3 on top of
the steam receptacle (Fig. F).
7. Lay the accessories in the basket 3
(Fig. G).
8. Place the lid 1 on top of the basket 3
(Fig. H).
9. Insert the mains plug into a suitable
socket.
10.Switch on the device by sliding "ON/
OFF" switch 8 to "ON".
if indicator light 9 is already on,
N.B.:
start switch 7 has already been pressed
accidentally.
11.Start sterilisation by pressing start
switch 7.
Indicator light 9 comes on (Fig. I).
The steam steriliser automatically goes to
standby after sterilising and the indicator
light will go out.
12.To end sterilisation prematurely, slide
"ON/OFF" switch 8 to "OFF".
Warning!
Directly after switching off, the
appliance will still contain steam,
which will, to some extent, escape
through the steam outlet valve.
You should therefore take care not
to scald yourself.
equipment to cool down while
sealed for at least three minutes.
Directly after sterilising the bottles
will be very hot and should only be
removed using the tongs supplied.
Switch the device off after every
Beware!
sterilisation procedure by sliding "ON/OFF"
Allow the