Tightening Torques For Screw Connections; Reviewing The Braking Distance; Cleaning - BMW Cruise Bike Manual De Instrucciones

EN
It is measured from the top of the seat to the middle of the bolt on
the pedal axle. In order to adjust the seat height, we will use the
clamp screws that fasten the seatpost to frame.
Warning: For security reasons, the seat height may not
exceed the reference point set for the seatpost (horizontal mark
for the minimum configuration).

3.5 Tightening torques for screw connections.

In any type of assembly, the appropriate wrenches and a clamping
force must be used that are not too high. If when tightening or
blocking, you realize that the threads are damaged, you should
change the corresponding nuts or bolts. Later, the tightening
torques will be applied that correspond to each type of thread.
Recommended
thread sizes
M4x0,7
M5x0,8
M6x1
M8x1,25
M8x1
M10x1,5
M10x1,25
36
Tightening
torques (in Nm)
3 - 4
6 - 8
10 - 14
25 - 35
27 - 38
49 - 69
52 - 73

3.6 Reviewing the braking distance.

Before each use, you should analyze the perfect operation of the
front and rear brakes. Worn cables must be changed immediately.
We recommend that you squeeze both brakes evenly to avoid falls,
especially when the road is wet.
In damp terrain, the braking distance increases 40% compared with
dry terrain.

3.7 Cleaning.

In order to properly maintain the bike, we recommend that you follow
these measures of basic prevention:
■ Clean dirt and mud with a damp sponge and a light cleaning
product. When cleaning the paint, to not use solutions or very
strong alkaline cleaning products.
■ The plastic parts should only be cleaned with soapy water.
■ The tyres may be cleaned with a sponge or a brush and soapy
water.
■ After cleaning the bicycle, dry it by carefully rubbing it with a soft
cloth.
■ After each wash, you should grease the transmission elements.
Warning: Avoid using pressure cleaning apparatuses and do
not use steam cleaners at all times.