Ryobi TSS120L Manual Del Operador página 20

 If the front or back edge of the saw blade angles away
from the square as shown in figures 21 - 22, adjustments
are needed.
 Loosen the fence adjusting screw, push the sliding fence
approx. 1 in. to the right to get past the set screw, then
lift to remove the sliding fence from the miter fence.
MITER
SLIDING
TABLE
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER
SLIDING
TABLE
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
ASSEMBLY
BLADE
SQUARE
Fig. 21
BLADE
SQUARE
Fig. 22
20 − English
 Using the blade wrench provided, loosen the socket head
screws that secure the miter fence to the miter table.
 Rotate the miter fence left or right until the saw blade is
parallel with the square.
 Retighten the screws securely and recheck the blade-to-
fence alignment.
SET SCREW
FENCE
ADJUSTING
SCREW
SOCKET HEAD
SCREW(S)
SLIDING
MITER
FENCE
SLIDING
MITER FENCE
Fig. 23
SOCKET HEAD
SCREW(S)
Fig. 24