KUKEN EASYclean 6000 Manual Del Usuario página 29

Problems
Clean Water Tank Indicator Display Is
Incorrect
The aspirate is weak
Clean water tank is leaking
No water comes out when spraying
Without voice
Self-cleaning mode does not work
There are drops of water in the air
outlet
EasyClean shakes when used
The flap "empty the water tank" is
always activated
Codes of
mistake
FF:01 Overvoltage on load.
FF:02 Over current in load.
FF:03 NTC Open circuit / Short circuit.
FF:04 Replace the battery.
EN
Possible reasons
• Not calibrated.
• The Hepa is blocked.
• The volume of clean water is greater than
the valve.
• The clean water tank is not installed
properly.
• The cap is not screwed on properly.
• The clean water tank is empty.
• The clean water tank is not installed
properly.
• The voice switch is off.
• Your version excludes voice.
• EasyClean does not connect to the power
supply.
• The dirty water tank is full.
• There is a shortage of clean water in the
tank.
• The Hepa is not installed.
• EasyClean bent down hard.
• EasyClean sucked in the liquid foam.
• The brush roller is not installed
good.
• HEPA is blocked.
• The dirty water tank is full.
Possible reasons
29
• Remove the clean water tank, then
start EasyClean and spray the spray,
turn EasyClean off until the pipe is
drained. Then press the "Switch Button"
and "Eco / Max Button" for 5 seconds
until the digital display flashes twice,
then check again.
• Please check and clean the Hepa.
• First dry the Hepa.
• Check and reinstall the scraper.
• Pour in a little water until the volume
is below the valve.
• Reinstall the water tank.
• Screw the cap on tightly.
• Please fill the clean water from the
tank.
• Reinstall the water tank.
• Turn on the voice switch.
• Check and confirm with the local seller.
• Check and connect the power supply
properly.
• Empty the dirty water tank.
• Fill the tank with clean water.
• Check and install HEPA.
• Use the machine correctly.
• Empty the dirty water tank on time.
• Check and reinstall the rotating brush
as a guide.
• Clean the HEPA.
• Empty the dirty water tank.
Soluciones
Replace the adapter.
Replace the adapter.
Replace the battery.
Replace the battery.
Solutions