Sherwood RD-6506 Instrucciones De Funcionamiento página 16

RD-6506(A)_ENG_110408_RD-6506(A)_ENG 2011-04-11 오전 11:41 페이지 16
5.
Operate the selected component for playback.
• When playing back the program sources with surround
sound, refer to "ENJOYING SURROUND SOUND" on
page 18.
6.
Adjust the (overall) volume.
MASTER VOLUME
DOWN UP
7.
To mute the sound.
MUTE
• "MUTING" is displayed.
• To resume the previous sound level, press it again.
8.
To listen with the headphones.
PHONES
• Be sure to switch the speakers off.
• When listening to a DTS or Dolby Digital program source,
if the headphones are plugged in and the SPEAKER
button is set to off, it enters the 2CH downmix mode
automatically. (For details, refer to "2CH downmix
mode"on page 18.)
■Note:
• Be careful not to set the volume too high when using
headphones.
Adjusting the tone (bass and treble)
9.
Enter the tone mode.
TONE
• The tone mode is
displayed for several
seconds.
10.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired tone mode.
TUNE
• Each time these buttons are pressed, the tone mode is
selected as follows :
OFF : To listen to a program source without the
↕
tone effect.("DIR" lights up.)
ON : To adjust the tone for your taste.("DIR" goes off.)
■When the TONE is set to ON to adjust the tone
(bass and treble).
11.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired tone.
PRESET
• Each time these buttons are pressed, the tone is selected as
follows:
→ BASS ↔ TRE (treble) ↔ TONE: ON ←
12.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to adjust the selected tone as desired.
• The tone level can be adjusted within the range of -10 ~
+10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
• If the tone display disappears, start from the step 9 again.
16