Tools Required - Whittier Wood Products 232W Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
Phillips Head Screwdriver, Mallet or Padded Hammer and Tape Measure
1. Determine from the chart below
which configuration you are using to
determine the correct instructions for proper installation.
Drawer Kit
232W Standard Alder
3-Drawer Kit
243W Wider Alder
3-Drawer Kit
232W DRAWER
FIG. 2
Small holes on LEFT edge
2. Arrange Front Slide Support
(A) and Rear Slide Support (B)
as shown in FIGURE 2.
Make sure the holes are
oriented as shown in the
diagram.
232W / 243W

TOOLS REQUIRED:

232W Standard 3-Drawer
Kit shown in Figure 1.
FIG. 1
Use 224W Standard
with
Console Base
235W Wide
Use
Console Base
with
INSTALLATION IN A
Large holes down center
Front
Small holes on LEFT edge
Base Unit
Left Shelf
Compartment
Right Shelf
Compartment
Large holes on edge
Rear
Small holes on RIGHT edge
Start with Step:
Follow Steps 2 - 5
Follow Steps 6 - 9
Follow Steps 10 -13
224W BASE
Large holes down center
Small holes on
Front
Rear
232W/243W — Page 3
RIGHT edge