LEAF AFi Guia De Inicio Rapido página 80

16
Removing the AFi Back
Rotating the AFi Back
The Leaf AFi digital camera is provided with the back attached to the
camera, and does not need to be assembled. If you wish to remove the
back, do the following:
Holding the AFi camera securely, push the back release inwards and
upwards, and gently pull the AFi back away from the camera body.
Note: It is highly recommended to use the covers provided to protect the back
of the camera and the front of the AFi back when not in use.
Holding the AFi camera securely, push the back release inwards and
1.
upwards, and gently pull the AFi back away from the camera body.
Rotate the AFi back counterclockwise by 90°.
2.
Line up the AFi back and the camera.
3.
Insert the pins of the AFi back into the holes on the rear end of the
4.
camera.
Hold the back parallel to the body, and push the back and the camera
5.
together making sure that each pin is locked at the same time.
Tip: When the back is detached from the camera and not in use, please use the
protection cap.
Chapter 2 – Getting Started