Schüco IPE 2700 SN 05 Manual Del Usuario página 42

Installation
3.3 Installing the communication equipment
Interface overview
38
3 4
1 = N
2 = L (feed-in phase)
3 = not used
4. Screw plug housing to plug. To do this, push the outer ring of the plug toward
the connector housing. Tightening torque: 1-2 Nm.
5. Tighten the cable gland.
Tightening torque for cable sheath diameters between 13 and 20 mm: 6 to 8 Nm
NOTE
Make sure the line is provided with a strain relief device. When using cables with a
diameter of less than 16 mm, the line must be relieved just behind the connector.
1
1 Ethernet connection
2 no function
3 CAN IN
4 CAN OUT
5 S0 interface (pulse output, e.g. for
large display)
The diagram shows the connections
inside the AC connector. These are
indicated by the cut-out at the
PE connection.
4 = not used
= PE (protective earth conductor)
3 4 5 6 7
6 Terminal for temperature and irradi-
ance sensor
7 RS485 interface
8 Terminal for alarm relay
8
IPE 2700 - 5000 SN 05