Installation Steps - LUND 26510015 Instrucciones De Instalación

Installation Steps

Identify the (3) mounting locations for each bracket by looking under the driver side of the vehicle and finding the holes in the rocker
panel. Note which holes correspond with the holes in the running board brackets. Mark the holes in the rocker panel with a grease pencil.
1
Beginning at the driver side rear, remove and discard
tape covering upper mounting holes in rocker panel.
2
Carefully thread plastic retainer over bolt plate stud
until flush with rocker panel, in order to assist with
holding bolt plate fixed in place while continuing the
4
NOTE: Actual application may vary slightly from illustrations.
Remove tape to reveal upper
mounting hole location
installation.
Front passenger side shown
Insert bolt plate through mounting hole in rocker
panel while holding on to the stud. Align the welded
nut on the bolt plate with the bottom hole on the right
3
Repeat Steps 2 and 3 for remaining (2) driver side locations.
NOTE: On the Front Bracket ONLY, align the welded nut on
the bolt plate with the bottom hole on the left side.
Plastic retainer threaded onto bolt plate stud
5
Page 2 of 4
side.
Align welded nut on bolt plate with this hole
NOTE: Use caution not to drop the bolt
plate inside the rocker panel.
and flush against rocker panel