Cleaning And Care - oneConcept 10030880 Manual De Instrucciones

COOL button
Please noted that the COOL LAMP will flashing when you press the Cool button if there is no or lacked
water in water tank.
Before operating the unit in Cool mode, make sure the escape valve for the water tank is properly
fixed. Then proceed to add clean water into the water tank. While adding the water, make sure that
you keep an eye on the water level indicator to make sure that you do not OVER or UNDER FILL the
unit. Press the button Cool after you have added the water and the unit should commence to blow
cooler air. The cool light will light on at the same time. When you press the button Cool again, it will
stop working, the cool light will also go out.
If you find that the air after Step 1) is still not cool enough, you can add additional ice block into
the water tank directly by opening the water tank cover. Be sure not to exceed the icebox capacity
otherwise damage to the unit or electric shock may occur.
If you wish to use an Ice box instead of ice block, just place it directly into the tank by opening the
water door. It will be good cooling efficiency if you place it in your refrigerator and let the ice pack
freeze for 1 to 2 hours.
You may complete pull out water tank, then replace water in the water tank or clean water tank,
Under the cooling work condition, the appliance will delay 5 minutes to stop working when you shut
off the unit or timing finished, during the extended period, the timer pilot lamp is flashed.
HEAT button
the default setting is low Heater 1300 W, so once you press button again, it is high Heater 2000 W
This machine can memory heater condition.

Cleaning and Care

How to knock down the dust-proof
bracket and honeycomb filter
1. Pull out the dust-proof bracket
2. Rotate the filter knobs outwards like up
photo.
3. Take up the honeycomb filter
10