LaserLiner MultiMeter-PocketBox Manual De Instrucciones página 14

Voltage measurement DC/AC
3
To take a voltage measurement, turn the
rotary switch to position „
Then connect the measuring contacts to
the object to be tested. The measured
value acquired and the polarity appear on
the display.
4 Voltage measurement AC
To take a voltage measurement, turn the
rotary switch to position „
Then connect the measuring contacts to
the object to be tested. The measured
value acquired and the polarity appear on
the display.
Resistance measurement
5
To measure the resistance, turn the rotary
Then connect the measuring contacts to
the object to be tested. The measured
value acquired appears on the display.
If „O.L." appears on the display instead
of a measured value, either the measuring
range has been exceeded or the
measuring circuit is not closed or has
been interrupted. Resistances can only be
measured correctly in isolation; therefore,
the components might need to be
disconnected from the remainder of the
circuit.
14
GB
black
".
black
".
black
red
red
red