Enarco TIFON 600 Manual De Instrucciones página 25

CHANGE OF BLADES
Be careful when replacing old blades. Due to the way the blades wear, the old blades become very
sharp, like a knife blade. As a safety precaution, use very heavy duty gloves during this operation to
prevent the hands being cut. Remove bolts and lock washers on each trowel arm and remove the
blades. Before installing new blades clean all concrete/cement from bottom and side of the trowel,
be sure trowelling edge of the blade is behind the trowel arm. Install bolts and lock washers on each
trowel arm and fasten securely.
TIGHTEN THE V BELTS
If you notice a loose on V belt, check the tightness.Especially in first using and V belt change.Check
the V belt tightness after 8 hours later.Using your head finger push the V belt from its middle point.It
must strech about 2cm.If it strechs more, it is loose.
For tightening; loose the motor fixing screws.(tiil motor moves away on the table) Loose the motor
lock nut.Loose the screws, push the motor backward. Checking the V belt tighteness, do the same
operations.Until tighteness of V belt is desired value, screw the motor luck nut, and then screw the
motor fixing screws.
V-BELTS INSTALLATION AND MAINTENANCE
WHILE INSTALLING THE V-BELT:
RIGHT
Install the V-belt by closing the centre
of pulleys to each other and tighten.
- Adjust the pulley edges with respect to pulley shafts and V-belt grooves to be on the same plane.
- Fix the unbalanced pulleys.
- V-belts lengths should be the same in multi-grooved pulleys.
- Change all V-belts at the same time in multi-grooved pulleys to prevent worn out.
TROWELS TIFON 600/900/1200 WITH PETROL ENGINE
WRONG
While installing the V-belt do not use a crowbar.
en
9