OJ Microline OCD5-1999 Instrucción página 7

FIG. 1 - CONTENT
• Thermostat
• Sensor
• Display disassembly tool
The thermostat is an electronic PWM/PI thermostat for tempera-
ture control by means of an NTC sensor located either externally or
internally within the thermostat.
The thermostat is for flush mounting in a wall socket. A baseplate
for wall mounting is also available.
This thermostat can be used as a controller for electric room heat-
ing pursuant to EN50559.
Product programme
OCD5-1999/MCD5-1999
FIG. 2 - WARNING – Important Safety Instructions
Disconnect the power supply before carrying out any installation or
maintenance work on this thermostat and associated compo-
nents. The thermostat and associated components should only be
installed by a competent person (i.e. a qualified electrician). Electri-
cal installation must be in accordance with appropriate statutory
regulations.
FIG. 3 - THERMOSTAT PLACEMENT
Mounting of sensor
The floor sensor contains a safety extra-low voltage (SELV) circuit,
allowing it to be placed as close to the floor surface as possible
without having to take account of the risk of shock should the sen-
sor cable become damaged. The two wires connecting the sensor
to the mounting box must be additionally insulated, e.g. shrink flex.
OCD5-1999
Instruction
English
Clock-thermostat with two sensors:
floor sensor and built-in room sensor.
© 2021 OJ Electronics A/S 7