Environmental Protection - Ubbink MystMaker Indoor I Manual De Instrucciones

Initiating
• Place the MystMaker I into your room fountain or water container so that it is covered with water.
• Connect the provided transformer on to the supply line of the MystMaker I and also in an adequate mains socket.
• When the control lamp of the MystMaker I illuminates, the device is activated and creates water mist. If the
water level falls below the minimum water level, the water level control sensor switches the MystMaker I off
automatically.
• The ceramic disc (membrane) has a limited life span and has to be replaced after approx. 3000 hours.
At the latest, a replacement is necessary when mist is not created when the control lamp illuminates.
Replacement of the membrane
The ceramic disc (membrane) is a wearing part. If the misting effect is reduced or does not function at all, the ceramic
disc has to be replaced.
This can be acquired as replacement part at your Ubbink specialist dealer (Article number 1387093).
• For replacement, use the special tool (1) that has been provided.
• Remove the plug of the mains adapter from the socket and remove the MystMaker I from the water.
• Remove any possible lime residues in the area of the ceramic disc (membrane) using water with vinegar.
• Make sure that the device has been completely dried before unscrewing it.
• Turn the threaded ring (2) in an anticlockwise direction using the special tool (1).
• Now remove the ceramic disc carefully.
• The ceramic disc is very sensitive. Now place the new ceramic disc carefully into the MystMaker I using the correct
side with the circle markings underneath (5b). Take care that the rubber seal (4) has been set correctly and is not
damaged.
• Now carefully screw the threaded ring (2) back into the MystMaker I in a clockwise direction and initiate the
MystMaker I once again.
2
Guarantee
We give a guarantee of 2 years against proven material and manufacturer faults that apply from the date of purchase:
The original sales receipt has to be presented as proof of purchase if claims are made on the guarantee. Any complaints
that do not fall under the guarantee are where they are caused by faults that are because of disregard of the safety
regulations through the mounting and user faults, lack of care, influence of frost, improper repair service, resorts of
violence, third party negligence, overstressing, mechanical damages or through the exposure to foreign bodies. All
complaints of partial damages and / or problems that have been caused by worn parts are also excluded from the
guarantee as well as damage by plants and animals.

Environmental Protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
4