Technical Data; Vibration Information - Worx LEAFJET WG543E Manual De Instrucciones

TECHNICAL DATA

Type Designation WG543E WG543E.9 (520-559
- designation of machinery, representative of
blower)
WG543E
Voltage
Maximum air
volume
Maximum air
velocity
Charging time 2 hrs (approx.)
Machine weight 1.7 kg
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
NOISE DATA
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.

VIBRATION INFORMATION

Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
20V Cordless Blower
WG543E.9
20 V Max.**
I: 518 m /h II: 696 m /h
3 3
(Air volume mode)
I: 153 km/h II: 209 km/h
(Air speed mode)
/
1.1 kg
L = 78.0 dB(A)
pA
3.0 dB(A)
L = 92.6 dB(A)
wA
3.0 dB(A)
a < 2.5 m/s
h
K = 1.5 m/s²
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
ACCESSORIES
Battery pack (WA3553)
Charger (WA3880)
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
OPERATION
INTENDED USE
The blower is intended for residential use only. Use the
blower outdoors to move yard debris as needed.
ASSEMBLY AND OPERATION
ACTION
2
ASSEMBLY
Charging the battery pack
Your battery pack is UNCHARGED, you must
charge before use.
More details can be found in charger's
manual.
WARNING! The charger and battery
pack are specially designed to work
together, so do not attempt to use any other
devices. Never insert or allow metallic
objects into your charger or battery pack
connections because of an electrical
failure and hazard will occur.
WG543E WG543E.9
1 /
1 /
FIGURE
See Fig.
A1, A2
EN
11