Panning And Rotation Test - Walimex Pro StabyFlow Manual De Instrucciones

6. Panning and rotation test

• Arrange the steadycam on the stationary
lamp tripod horizontally to test the dropping
movement.
• If the slide drops too quickly, correct the
number of weights on the weight block.
• If the slide drops too slowly, correct the
length of the steadycam and/or the centre
of gravity of the unit of handle, support and
spring arm receptacle:
Changing the lengths of the steadycam:
• For this purpose loosen the fastening
screw for the support length.
• Move the rod approx. 1.3 cm towards
the weight block.
• Tighten the fastening screw for the
support length.
Changing the centre of gravity of the unit
of handle, steadycam and spring arm
receptacle:
• For this purpose loosen the fastening
screw.
• Correct the centre of gravity of the unit
of handle, steadycam and spring arm
receptacle or the weight unit.
• Tighten the fastening screw.
• Repeat the dropping test.
26
NOTE
The dropping time of the camera slide must be between 2 and 3 seconds;
the slide should not rotate.
• You may need to repeat some of these steps, until the system is perfectly
balanced.
• Arrange the camera slide vertically to be able to conduct the panning test.
• If the slide is not arranged 100% vertically, you may have to execute some
of the steps several times.
27