Environmental Protection - Worx WT626 Manual Del Usuario

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for dry sanding of
wood, plastic, filler and coated surfaces.The
sander is not to be used for plastering。
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Fitting &Removing the
Sanding Paper
Paper Punch (Optional)
Attaching the Dust Box
Caution: To prevent
the possibility of
sanding dust or foreign
body being thrown into
your face or eyes, never
attempt to use your
sander without the dust
box properly installed.
Emptying the Dust Box
-For more efficient
operation, empty dusts
box every 5-10mins.
Using the Dust Extraction
Adapter
OPERATION
Plugging in the power
Switching On/Off
Variable speed control
WORKING HINTS FOR YOUR
FINISHING SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at
very low speeds. Always use sand paper that is
suitable for the material you want to sand.
Finishing Sander
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the sanding finish.
Start your sander before sanding and turn it off
only after you stop sanding. For the best results,
sand wood in the direction of the grain.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sandpaper to wear away it will
damage the base-plate. The guarantee does not
Figure
cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit for
the final surfaces. If necessary, first make a test
See Fig. A1, A2
run on scrap material.
Use only good quality sandpaper.
See Fig. B
The sandpaper controls the sanding efficiency,
not the amount of force you apply to the
tool. Excessive force will reduce the sanding
efficiency and cause motor overload. Replacing
the sandpaper regularly will maintain optimum
See Fig. C
sanding efficiency.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
See Fig. D1, D2 maintenance.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable
parts in your power tool. Never use water or
See Fig. E, F
chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
See Fig. G
slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through
See Fig. H
the ventilation slots. This is normal. If the supply
See Fig. I
cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
local authorities or retailer for recycling advice.
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
9
EN