Statement Of Use; Product Data; Maintenance Instructions - CP FAS 3000 Manual De Instrucciones

STATEMENT OF USE

This product is intended to be used to monitor the operation of CP fastening tools. No other use permitted. For
professional use only.
DISPOSAL
To be disposed of in accordance with local legislation.
© COPYRIGHT 2007, CP
All rights reserved. Any unauthorized use or copying of the contents or part thereof is prohibited. This applies in particular
to trademarks, model denominations, part numbers and drawings. Use only authorized parts. Any damage or malfunction
caused by the use of unauthorised parts is not covered by Warranty or Product Liability.
WARNINGS
1 Use an air supply, which is: water free, filtered and regulated to 6.3 bar.
2 "WARNING: THIS APPLIANCE MUST BE EARTHED"
3 This appliance is only to be serviced by CP authorised representatives.
4 Disconnect from the power supply before servicing.
5 Failure to comply with these operating instructions may impair the safety of this equipment.
6 Must not be used in explosive atmospheres.
EMC
This device has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the
FCC Rules. Any changes or modifications not expressly approved by CP Desoutter could void the user's authority to
operate this device."

PRODUCT DATA

Electrical Supply:
Connections:
Mass:
Temperature:
Max. Humidity:
Dirt & Dust protection:
Ventilation Requirements:
Earthing Requirements:
The FAS3000 may be bench mounted or wall mounted using the holes provided on the unit.

MAINTENANCE INSTRUCTIONS

Replace as necessary the fuse, see figure 1.
Any other servicing to be carried out by CP Authorised Representatives.
Supply Max Fuse
220 - 230V 0.5A (T)
110 - 120V 1.0A (T)
FAS 3000
110 ~ V 60 Hz / 230 ~ V 50Hz I/O
as Detailed in -Remote Interface"
3 kg
- 5 / 40 Centigrade
95% Rel Humidity (Non Condensing)
IP40
None
As per warnings
Part no 2050479093
Issue no 02
Series no -
Date 12/2006
Page 3 / 59
Fuse location