Haier HLP0R02AXW Instrucciones De Instalación página 8

4. Cut the ties holding the support braces to the frame, and make sure the bolts in
the cross braces are loose.
5. Fasten the two support braces to the stack stand using the hex-head bolts, flat
washers and lock nuts (provided).
6. Using a 1/2" wrench, completely tighten all 4 of the support brace nuts.
j k
7. Using a 1/2" wrench, completely tighten all 6 of the cross-brace nuts.
NOTE: Use a 7/16" wrench to tighten the pivot nut at the center of the rear cross
brace.
e
f
6
c
g
c
Support Brace
Hex-head Bolt
Lock Nut
Flat Washer
Cross Braces
Pivot Nut