Wolf KG Top 530 Instrucciones De Montaje página 24

Installing the
centre cover
22
21
23
Fitting the casing panels,
adjusting the seal
24
Installation instructions
The rotor hub is equipped with a grease fitting M6 (item 24) for continuous
Please
greasing of the bearing.
note
The hub cover features an aperture with removable plastic plug for accessing
the grease fitting. The removable plastic plug must be in line with the position
of the grease fitting.
- Use 10 bolts 4.2x13 (item 21) to fit the cover (item 22) to the rotor struts (item 25).
The covers consist of two parts on each side.
One half contains an aperture for accessing the grease fitting. The aperture has a
removable plastic plug Ø 40 (item 23).
If the TWHE has a removable front panel (see chapter Preparation), refit the casing
panel (item 4).
Around the perimeter of the rotor (on front segment – item 26), use the brackets (item
28) to adjust the seal (item 27) so that the gap between rotor and seal is at least
2 mm at the highest point. On the dividing strip (item 29) and purging chamber (if
installed), adjust the seal in the same way.
26
29
26
28
27
25
23
27 28
3065279_201804
24
2 mm