Assembling The Vacuum Cleaner - ARIETE Diablo 1600 Manual De Instrucciones

GB
DO NOT THROW AWAY THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE (FIG.1)
1 Hand grip
2 Suction control
3 Flexible nozzle
4 Extension tube
5 Extension tube fastening ring
6 Bag full indicator
7 Carry handle
8 On/Off switch
9 Cord re-wind switch
10 Hard floors/carpet selector
11 Floor brush
12 Dust bag compartment release switch
13 Dust bag compartment
14 Crevice nozzle
15 Paper dust bags

ASSEMBLING THE VACUUM CLEANER

Push the nozzle connector into the nozzle compartment until it locks into place (FIG. 2). To release the nozz-
le connector, press the buttons on its sides and remove the connector from its seating (FIG. 3).
CAUTION: Before fitting or removing attachments, always make sure that the vacuum cleaner has been
unplugged from the mains power.
ATTACHMENTS
Extension tube
Insert the extension tube into the hand grip and then fit the required attachment.
Once the attachment has been fitted, it is possible to lengthen the extension tube by turning the fastening
ring (FIG. 4a) and setting the tube at the required length (FIG. 4). Tighten the ring to block the tube in posi-
tion.
Floor brush (11)
This is used for cleaning large areas and to reach any corner with ease.
- Cleans rugs and carpets without the need for a brush attachment. Press the tip switch marked with the
carpet symbol
- Smooth flooring, such as PVC, parquet or tiles, is best cleaned and cared for if the brush attachment is
used. Press the tip switch with the smooth floor symbol
and this will raise the brush.
8
and the brush will come out.