HumanTechnik LA-215 Instrucciones De Servicio página 10

Back panel:
Line Input control (12): Use this knob to
increase or decrease the input signal.
Operating instructions
1 Use the connection cable included with
the device to connect an audio source to
one of the two line in jacks (13, 14) on the
back panel. If your TV set or your sound
source does not have a direct connection,
use a microphone, which you plug into the
microphone jack B (15). A second micropho-
ne can be plugged into jack A (16) at the
same time if one is required.
2 Connect the two ends of the loop (Fig. A)
with the input jacks (11). Press the red and
black button to insert the cable and release
the button to lock it in place. Make sure
that only the metal wire is touching the
contacts. To remove the cable, press the
button again and pull the cable out.
Fig. A
10 English
- Turn the volume control down to
the lowest level before you plug
the power cord into the wall out-
let.
- Press the Power on/off button (7)
to switch the loop amplifier on.
- Now anyone wearing a hearing aid must
set it to the T or MT position.
- Adjust the volume control to the desired
volume..
Important: Before you connect or disconnect
an audio source, always pull the power
cord out of the wall outlet.
LA-215 loop amplifier
Sound source, e.g. TV or stereo
Lay the loop under the carpeting or
along the baseboard