Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTAllATION
Models 964MSD, 965MSD
Portable toilets are legally acceptable for use in vessels not having permanently installed toilets, as
determined by the United States Coast Guard . However . some states and the Canadian province of
Ontario require a permanently installed portable toilet, such as the 964MSD and 965MSD .
Installation Possibilities
964MSD/965MSD Rear View
1-1/2" Deck
Waste Fitting
2" Hose Clamp
3/4" Hose Clamp
5/8" Thru-hull Vent Fitting
(installed above water line)
3/4" Hose Clamp
5/8" Vent Fitting
(included)
MArINE SANITATION rEGUlATIONS
All boats with fixed toilets in U .S . waters and in the waters of some other countries
are required to have an operable, permanently installed marine sanitation device
(MSD) . Series 970 MSD models, when permanently installed in a boat, are holding
tank or Type III systems as defined by the U .S . Coast Guard . Type III systems permit
operation of the toilet without direct discharge of untreated waste after every flush . Type
III systems can be discharged at marina dockside pump-out stations or, if in coastal
waters, a minimum of three miles offshore . Overboard discharge capability must remain
secured while within the three-mile limit . If an overboard discharge pump is activated by
a keyed switch in the toilet compartment, the key must be removed at all times except
when discharge pump is operating and in the process of vessel operation .
Sewage from any source should not be discharged directly into boating waters .
If you are interested in learning more about this issue, please visit our website at
www .Dometic .com .
SeaLand OdorSafe Plus
Sanitation Hose
5/8" Vent
Hose
1-1/2" Hose
Adapter (included)
Remove Cap From Bottom
Tank Vent Adapter
1-1/2" Swivel Nut
(included)
1-1/2" Gasket
(included)
964MSD/965MSD
Remove 1-1/2" Cap & Plug
From Bottom Tank Waste
Discharge Adapter
Dockside Pumpout
Direct Overboard Discharge
Dockside Pumpout
To Remote Holding Tank
Fresh Water
Tank
Holding Tank
This symbol appears
on the discharge fitting
of MSD models.
5
Publicidad
Tabla de contenido
