Team kalorik TKG WSP 1001 Manual De Instrucciones página 17

Fax +32 2 359 95 50
the separate cover close to the five inner ribs and let the bottom edge inside the inner
side of the square hole to make sure it is well sealed and there is no water leakage. Good
condition: the separate cover is inside the inner side of the square hole and close to the 5
ribs.
For a perfect finishing:
Slightly sweeping manually with a dry wiping cloth will allow you to remove all wet remaining
traces. Indeed, depending on the methodology of each user, a few residual traces of water
can remain, you just have to wipe them with a dry piece of linen, your windows will always be
clean and the traces of grease will be completely removed after the passage of your device.
An excessively dirty water in the tank can be at the origin of residual traces, after drying, it is
recommended to empty the water of the tank after each use and sometimes during the
cleaning of especially dirty surfaces.
The wiping cloths must also be regularly changed, depending on their dirt state.
Do not project spray to eyes with or without product, or on surfaces of electronic
components, such as plug, switch, cable, stereo equipment, computer screen, or household
appliances.
AFTER USE & MAINTENANCE
•
Always unplug the appliance before cleaning.
•
Cleaning the filter and the dust collector is extremely important as it allows the optimal use
of your appliance and eliminates the unpleasantness due to bad smells that can occur
after having vacuumed liquids or humid particles.
•
Remove the dust collector by pressing the release button situated on top of the
appliance. We advise you to do this over a dust bin.
•
Remove the filter unit in the dust collector as described above.
•
Empty the dust compartment and clean it with soapy water if necessary.
•
To clean the filter you can detach it from its holder. You can then take the filter and clean
it in soapsuds if necessary. If you use soapsuds, rinse the filter with clear water and let it dry
before putting it back into the appliance.
•
Once the filter is clean and dry, put it back in its holder and reinsert the filter holder in the
dust collector. To do so, make sure the ribs in the dust compartment face the grooves
situated on the edge of the filter holder. The correct position of the filter holder is extremely
important, as it guarantees the tightness between the dust compartment and the motor.
•
If the filter is too dirty or damaged, it must be replaced. To do so, please contact the
nearest customer service.
•
After having replaced the filter, attach the dust compartment to the motor unit.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Inner rib
Inner side
of square
hole
Small screwdriver
17
Assembly page 17/72
Handle
TKG WSP 1001 - 140418