Electrical Supply Connection - Cooper Lighting Solutions Metalux VT4S Instrucciones De Instalación

Figure 5.
Figure 6.
Figure 7.
Installation Instructions – VT4S LED Vaportite Luminaire Installation
Interior Access
To access the interior of the fixture, begin by unlatching
the lens and setting lens aside. The LED gear tray is then
removed by pressing outward on the tabs at the corners of
the fixture housing to release the gear tray (Figure 8). The
gear tray is tethered to the housing. After reinstalling the
lens, close all of the latches and press on the lens at each
latch location toward the back of the housing to ensure the
lens is seated properly.
Figure 8.

Electrical Supply Connection

The VT4S is suitable for wet locations and approved for
the IP ratings shown above. Please follow the specific
instructions based on the IP ratings used for your particular
installation. Apply thread sealant to all fitting threads and
use a backup wrench when tightening any fitting to the hub.
Refer to figures 9 & 10. Assemble the hub through the
housing access hole with the O-ring on the outside. Thread
the hub locknut onto the hub and tighten firmly. Do not
allow the outside portion of the hub and O-ring to rotate
when tightening.
For general wet location installations and IP65, IP66, IP67
and IP69 (IP ratings are based on fixture being mounted in
horizontal position with light facing down), use the supplied
connector hub and install either a suitably rated WT cord
grip and cord, or liquid-tight conduit and fittings.
COOPER LIGHTING SOLUTIONS
Press tab to release Gear Tray
IB519090EN Installation instructions
3