Hilti DD 150-U Manual De Instrucciones página 46

3.2 Intended use
The product described is an electrically powered diamond core drilling machine. It is designed for hand-
guided wet and dry drilling, for wet drilling with a drilling rig as through-holes and I or blind holes in (reinforced)
mineral substrates.
• The tool may be operated only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
3.3 Bluetooth
®
This product is equipped with Bluetooth (optional).
Bluetooth is a wireless data transfer system by which the two Bluetooth-enabled products can communicate
with each other over a short distance.
To ensure a stable Bluetooth connection there must be a clear line of sight between the connected devices.
Application of Bluetooth functions on this product:
• Automatic switching on and off of a Hilti water supply system during drilling operation.
• Displaying service messages of a connected water supply system on display of the diamond core drilling
machine.
• Connection to a mobile device via the Hilti Connect App for service functions and transfer of product-
related analysis data.
Switching Bluetooth on/off
Hilti products are delivered with Bluetooth turned off. On first start up, Bluetooth is switched on
automatically.
•
To switch off, press and hold down the buttons
•
To switch on, press the buttons
Connecting products
The pairing with the water treatment system is sustained until the diamond core drilling machine is paired to
another water treatment system, or Bluetooth is switched off. Pairing is also sustained even when the products
are switched off and then on again; paired products always automatically re-establish their paired connection.
• To pair with a Hilti water treatment system or mobile terminal device, with Bluetooth switched on
simultaneously press the
The time frame for the connection to a different diamond core drilling machine is approximately 2
minutes. When the 2 minutes have expired, the connection process will be canceled.
License
Bluetooth is not available in all countries.
The Bluetooth word mark and the logo are registered trademarks and the property of Bluetooth SIG, Inc.
®
and Hilti has been granted a license to use these trademarks.
3.4 Display symbols and explanation of the multifunction display on the diamond core drilling
machine
For the following information to be displayed, the diamond core drilling machine must be ready for operation
(plugged in and PRCD switched on).
The displays may vary depending on the gear selection and the type of application.
Starting screen
Spirit level
38 English
and
and simultaneously.
and buttons.
The start screen is displayed when the diamond core drilling machine is
supplied with power. The Bluetooth status, the personalized name and the
serial number of the diamond core drilling machine are shown on the start
screen.
• You can change the product name that appears on the screen in the
Hilti Connect app (default: 'Your name here').
The diamond core drilling machine is not switched on. The display helps
you to level the system and to align the drill stand when drilling at an angle.
The display shows the alignment of the diamond core drilling machine
symbolically and in degrees.
• Angular accuracy at room temperature: ±2°
simultaneously for at least 10 seconds.
2204400
*2204400*