Cooper Lighting TQS1000 Manual De Instrucciones página 5

TQS1000325-1533.qxd
CAUTION: Always handle halogen bulbs with gloves or with a
clean soft cloth.Oil from your skin can cause premature failure of
the bulb.
Replacing the bulb
Step 1: Make sure fixture is turned OFF and unplugged.
Step 2: Turn wing nut on back of handle counterclockwise to remove handle.
Using a Phillips screwdriver loosen the screw on the front of the door.
Step 3: The door frame and lens assembly will swing down
allowing access to the bulb.
Step 4: Using gloves or soft cloth, press the old bulb to one
side of the spring loaded socket as indicated on the
metal reflector. Remove opposite end of bulb from the
other side of the socket. Remove the new bulb from
its package making sure not to touch bulb with bare
hands. Reverse this procedure to install a new
replacement bulb (Fig. 6).
Step 5: Replace the door frame and lens assembly and
secure it using a phillips screwdriver.
Aiming the fixture
Make sure the light fixture is in the OFF position and cool.
Loosen the knob located on the side of the light fixture housing.
Using the top tab handle tilt to desired position then retighten
knobs (Fig. 7). There is a stop that restricts the downward and
inward movement of the fixture for safety reasons. To prevent
overheating and risk of burns or fire, do not aim the fixture down
at an angle of more than 10 degrees from horizontal.
Two Year Limited Warranty
Cooper Lighting ("the Company") warrants this product ("the product") against
defects in material or workmanship for a period of two years from date of
original purchase, and agrees to repair or, at the Company's option, replace a
defective product without charge for either replacement parts or labor during
such time. This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product.
A purchasers receipt or other proof of date of original purchase acceptable to
the Company is required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb or failure
of the product caused by accident, misuse, abuse, lack of reasonable care,
alteration, or faulty installation, subjecting the product to any but the specified
electrical service or any other failure not resulting from defects in materials or
workmanship. Damage to the product caused by separately purchased,
non-Company brand replacement bulbs and corrosion or discoloration of
brass components are not covered by this warranty.
There are no express warranties except as described above.
Call for customer service and/or missing or damaged parts (800-334-6871)
4/3/06 1:45 PM Page 5
5
Fig. 6
Fig. 7