16 7.8.2 Buffer Battery - Nice Ten TN2010 Instrucciones Y Advertencias Para El Instalador

Led L4
Off
On
Flashing
Led L5
Off
On
Flashing
Led L6
Off
On
Flashing
Led L7
Off
On
Flashing
Led L8
Off
On
Flashing
7.8) Accessories
he following accessories are available with TEN. Refer to the Nice S.p.A. product catalogue for a complete and updated list of the acces-
sories.
SMXI / SMXIS Radio receiver, 433.92MHz with digital Rolling
Code
OXI Radio receiver 433.92MHz with digital Rolling
Code; equipped with extended Mode II to send
15 types of command to control unit
OView Remote control and programming unit with
graphic display
TNA2 Spare control unit for TN2010
OTA2 Support bracket for motor length 1250mm
OTA3 Support bracket for motor length 2000mm
7.8.1) Remote programming unit
In the specific case of connector BusT4 (see figure 32) the OView
remote programming unit can be connected, to enable a compre-
hensive and rapid management of the installation, maintenance and
fault-finding procedures. To access this connector, remove the
membrane as shown in Figure 32 and connect the connector in the
relative seat (Figure 33). The remote programming unit can be set at
a distance from the control unit, up to 100 m of cable; it can be con-
nected simultaneously to several control units. Up to a maximum of
16, and can remain connected also during normal operating of TEN;
in this case a special "user menu" enables delivery of commands to
the control unit.
32
28
Description
During normal operation, indicates "Stand-By" not active.
During normal operation, indicates "Stand-By" active.
• Function programming in progress
• If flashing together with L3, indicates that the door opening and closing acquisition procedure must be per-
formed (see paragraph "4.3 – Learning the door opening and closing positions").
Description
During normal operation, indicates "Long inversion" not active.
During normal operation, indicates "Long inversion" active.
• Function programming in progress
Description
During normal operation, indicates "Pre-flash" not active.
During normal operation, indicates "Pre-flash" active.
• Function programming in progress
Description
During normal operation, indicates "Current sensitivity control" not active.
During normal operation, indicates "Current sensitivity control" active.
• Function programming in progress
Description
During normal operation indicates that the installation is with 1 motor.
During normal operation indicates that the installation is with 2 motors.
• Function programming in progress
TNA4 Pair of transmission shaft lengths 1500mm
TNA5 Pair of standard straight telescopic arms
TNA6 Pair of standard curved telescopic arms
TNA8 Pair of transmission shaft lengths 200 mm
OTA11 Kit for external release by means of metal cord
OTA12 Kit for external release by means key operated
catch
TNA38 Gear device for 1 pair of transmission shafts
TS Warning sign table
PS324 Buffer battery
If an OXI type radio receiver is inserted in the control unit, the remote
programming unit enables access to parameters of memorised
transmitters.
These functions require a 4-core connection cable (BusT4) which
also enables updates to the TEN control unit firmware. Further infor-
mation is provided in the Oview programmer instruction manual; or
in the specific addendum on "Additional TEN functions with Oview"
available also at the website www.niceforyou.com.
33