NSK S-Max M500L Manual De Operación página 5

3. Insertion & Removal of the bur
TO INSERT THE BUR (Fig. 2)
Depress the Push Button and insert the bur into the chuck until it is secure. Release the button.
TO REMOVE THE BUR (Fig. 3)
Stop the handpiece. Depress the Push Button firmly and remove the bur.
CAUTION
Test that the bur is secure by gently pulling and pushing the bur without depressing the Push
Button.
4
4. Information about burs
1
· Do not use non-standard burs. The ISO standard shank diameter is ø1.59 - ø1.60 mm.
· Do not use bent, worn, damaged, or non-concentric burs. Such burs can cause damage to the handpiece.
· Do not exceed the bur speed recommended by the bur manufacturer.
· Always keep the bur shank clean. Entry of hard debris into the chuck via the bur shank could cause rotation slip and also prevent the bur from being
securely located in the chuck.
· Fully depress the Push Button and insert the bur into the chuck until it is secure.
· Do not use short shank burs in Standard Head handpieces.
Fig. 2
2 5. Lubrication, Cleaning and Sterilization
1
Refer to the Maintenance Guide
All handpieces can be autoclavable up to Max.135°C.
Fig. 3
OM-Z0135E.
All handpieces can be cleaned and disinfected with a Thermo-Disinfector.
5