Troubleshooting - Hamilton Beach 54614 Manual De Instrucciones

Optional Cleaning
1. Remove dispenser assembly cap
2. Wash dispenser and parts in hot,
soapy water. Rinse and dry
thoroughly. Do not soak.
NOTE: Do not remove seal rings
from adaptor.

Troubleshooting

PROBLEM
Blender leaks.
Ice not crushed.
Does not
blend well.
Does not dispense.
Dispenser leaks.
Cannot remove
cutting assembly.
840155505 ENv01.indd 7 840155505 ENv01.indd 7
3. Reassemble plunger inside of
by rotating dispenser body and rotate cap
counter- clockwise until tight.
clockwise.
Dispenser
Assembly
Cap
Plunger
Dispenser
Assembly
Body
PROBABLE CAUSE
• Tighten cutting assembly on jar.
• Make sure gasket is in place on cutting assembly.
• Make sure gasket is not damaged. If damaged, please
call our toll-free customer service number to order a
replacement.
• Make sure lid with filler cap is pushed down tightly
on jar.
• See ice crushing instructions in "Blending Specific
Foods" section.
• Make sure enough liquid has been added. A
minimum of 10 ounces (300 ml) is recommended.
• Make sure blender is ON.
• Make sure seal rings are in place on dispenser
adapter.
• Tighten dispenser cap (located above dispenser body).
• Loosen collar by holding jar and turning cutting
assembly counterclockwise.
Adaptor
Seal Rings
7
7/19/12 1:13 PM 7/19/12 1:13 PM