Using The Product - LUND 67840 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 41
GB

USING THE PRODUCT

Selection of fi lter cartridge
The product is equipped with three types of fi lter cartridges.
Rare juice fi lter - the cartridge is equipped with smaller openings. It allows to obtain juice with a very low content of pulp.
Dense juice fi lter - the cartridge is equipped with larger openings. It allows to obtain juice with pulp.
Ice cream fi lter - the cartridge has no openings. It allows the pulp to be ground and the juice to be kept in it. This pulp can be used
to make ice cream. This cartridge does not produce juice.
Product assembly and disassembly
The product must be assembled according to the below instructions. Only correct assembly ensures effi cient and safe operation.
CAUTION! Turn off the device and disconnect it from the power supply during all installation operations.
Remove the product from its packaging, remove all parts and then wash all parts in contact with the food according to the instruc-
tions in the section entitled "Product maintenance".
Set the drive housing according to the instructions. When selecting the location, space should be provided for placing the con-
tainers for the pulp and juice.
The bowl of the squeezer has two outlets. The round outlet with plug is used for draining off the squeezed juice. The rectangular
outlet is used to drain off the pulp. This outlet has a fl exible inner stopper.
CAUTION! The plug must always be pressed into the outlet opening (II) during operation. Failure to do so may result in leakage,
which may be the cause of product damage, electric shock and injury.
The plug makes it easy to clean the bowl.
Place the bowl on the drive housing. The bowl in the base has openings to fi t with the tabs in the drive housing (III).
Insert the selected cartridge into the frame with blades. The blades inside the frame should rest on the fi lter cartridge (IV) with
their full edge.
Insert the frame cartridge into the bowl. The mark on the edge of the fi lter cartridge should indicate the centre of the holder housing (V).
Slide the auger into the fi lter cartridge (VI). The upper surface of the auger should be parallel to the upper edge of the fi lter cartridge.
Cover the bowl with the lid. The cover shall be in contact with the edge of the bowl throughout its circumference. Place the lid so
that the tongue is close to the product handle, then turn the lid as far as it will go towards the handle so that the tongue of the lid
fi ts completely into the product handle (VII). The product has a fuse that will not allow it to be switched on if the cover is closed
incorrectly.
Place containers (VIII) under the juice and pulp outlet openings.
The product is ready for use.
To disassemble, perform these operations in the reverse order. Disconnect the power cord from the power outlet before disassembly.
Juicing
Fruit and vegetables shall be washed and divided into smaller pieces than the inlet opening so that they can be easily placed in
the inlet opening. Fruit and vegetables with thick skin or which are not normally eaten should be peeled off . All seeds and hard,
unfi t parts of fruit and vegetables must also be removed.
Connect the product to the power supply and switch it on.
The on/off switch allows you to set three positions:
O - device switched off ,
ON - the auger rotates in a direction that makes it possible to squeeze the juice,
R - the auger rotates in the opposite direction to the normal operation. In this position, hold the switch in the ON position. Releas-
ing the pressure on the switch will return the switch to the off position - O. Use this product function only when a jam occurs that
causes the auger to slow down or stop.
Wait until the rotation is complete and then insert the fruit or vegetables through the inlet opening.
CAUTION! If the device begins to vibrate after switching it on, if it makes an unusual sound, or shows any other signs of malfunc-
tion, switch it off immediately, unplug it, and check for the cause of the malfunction.
For maximum juice yield, push the fruit or vegetables in the squeezer using the provided pusher. The shape of the pusher is
adapted to the shape of the inlet opening. Do not attempt to insert the pusher in the opposite direction, it may cause the pusher
to get stuck in the throw-in hole.
CAUTION! It is forbidden to press fruit or vegetables with any other means than the provided pusher. Especially using fi ngers,
hands or cutlery. It is also forbidden to use the pusher from another model of squeezer. The auger may catch your fi ngers, hand
or other object and cause serious injury and/or damage to the product.
When squeezing the juice, check constantly that the juice and pulp containers are not full and empty them if necessary. The juice
O R I G I N A L
I N S T R U C T I O N S
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

67841

Tabla de contenido