Factory Reset - Buttons Air X Guia De Inicio Rapido

Here are the steps to follow when pairing
your earphones with a new device:
Put your earphones into the charging
case, and wait until the charging LED
indicators on the earphones are on, then
immediately press and hold the touch
panel on either earphone for 5s to take
out the earphone;
Your earphones will automatically enter
the mandatory pairing mode, and you
may pair with a device using the steps
described in the "Paring" section.
If your earphones fail to detect Bluetooth
signals or connect via Bluetooth and
other normal operations cannot be
restored, follow these steps:
Put your earphones into the charging
case and wait until the charging LED
indicators on the earphones are on, then
rapidly and successively tap the touch
panels on both earphones for 8 times,
and take them out of the case;
The LED indicators on both
earphones turn red and slowly
flash for 3 times, keep the two
earphones close to each other for
10s;
If the LED indicators on both
earphones turn white and flash
slowly, means factory reset is
succeeded.
Note:
If the LED indicators on both earphones fail toslowly flash 3 times in red simultaneously
in step 2, repeat step 1 until they do so;
Before factory reset, you are advised to ignore or delete "BUTTONS Air X" devices on
the Bluetooth list of connected devices.
1333-16国语言版-120x120v10.indd 5
Pair a new device

Factory Reset

Charge earphones
Put your earphones into the charging case and
ensure the two metal contact points are well
contacted, the charging box will automatically
charge the earphones.
Charging: LED indicators turn white and flash
slowly;
Charge complete: LED indicators are off.
Note:
5s
If LED indicators turn red and rapidly flashand the
system issues the voice prompt "Battery Low", it
means the earphone battery level is low;
When only one earphone is charged, LED indicators
on the charging caseturn yellow and flash;
When both earphones are charged, LED indicators on the
charging case turn green and flash;
Charge the charging case
Please only use the BUTTONS
charging cable (USB Type
A-Type C) provided by the
original manufacturer for the
charging case.
Charging: LED indicators on the charging
case turn green and flash;
x8
Charge complete: LED indicators on the
charging case are off;
Charge Fault: LED indicators on the charging case
turn red and rapidly flash.
Note:
The above light indication only applies to charge the charging case separately;
When the charging case cover is opened, the LED indicator turns red and is constantly
on, which signifies low battery of the charging case;
Please use standard 5V1A charger for this product, as those chargers out of
specification may damage the device.
Select proper eartips and wear them as shown in the picture
5
Ch a rg e
Ea r t i ps
2020/4/30 18:29:04