Turn On Your Headset; Pair It With Your Phone; Turning On/Off Call Alert Vibrate; Wear It How You Like It - Jabra BT500v Manual De Instrucciones

2

Turn on your headset

• Press the answer/end button to turn on your headset .
• Press and hold the answer/end button to turn off your headset .
3

Pair it with your phone

Before you use your Jabra BT500v, you need to pair it with your mobile phone.
1. Put the headset in pairing mode
•
Make sure the headset is on .
• Press the pairing button marked
2. Set your Bluetooth phone to 'discover' the Jabra BT500v
Follow your phone's instruction guide . This usually involves going to a 'setup, '
'connect' or 'Bluetooth' menu on your phone and selecting the option to 'discover' or
'add' a Bluetooth device . * (See example from a typical mobile phone in fig 5. )
3. Your phone will find the Jabra BT500v
Your phone then asks if you want to pair with it . Accept by pressing 'Yes'
or 'OK' on the phone and confirm with the passkey or PIN = 0000 (4 zeros).
Your phone will confirm when pairing is complete . In case of unsuccessful pairing,
repeat steps  to 3 .
4

Turning on/off call alert vibrate

The Jabra BT500v has a unique call alert feature that vibrates to inform you that are
receiving a call . The vibrate function is enabled when you first turn on Jabra BT500v .
If you turn on the device in the usual way without touching the volume button, the
vibrate function will remain enabled .
 . To turn off the vibrate, hold the volume down button while you turn the headset on .
2 . If you wish to re-activate the vibrate, hold the volume up button while you turn the
headset on .
5

Wear it how you like it

The Jabra BT500v is ready to wear on your right ear . If you prefer the left, gently rotate
the MiniGel™ ear piece 80° . See fig .  .
For optimal performance, wear the Jabra BT500v and your mobile phone on the same
side of your body or within line of sight . In general, you will get better performance
when there are no obstructions between your headset and your mobile phone .
4
.
6

How to...

Answer a call
• Tap the answer/end button on your headset to answer a call .
End a call
• Tap the answer/end button to end an active call .
Reject a call (dependent on your phone supporting this feature)
• Press the answer/end button when the phone rings to reject an incoming call .
Depending on your phone settings, the person who called you will either be
forwarded to your voice mail or hear a busy signal .
Make a call
• When you make a call from your mobile phone, the call will (subject to phone
settings) automatically transfer to your headset .
Activate voice dialing (dependent on your phone supporting this feature)
• Tap the answer/end button . For best results, record the voice-dialing tag through
your headset . Please consult your phone's user manual for more information about
using this feature .
Redial last number (dependent on your phone supporting this feature)
• Press the answer/end button .
Adjust sound and volume (dependent on your phone supporting this feature)
• Press the volume up or down (+ or -) to adjust the volume .
• To mute, press both volume up and down at the same time . A low beep alert plays
during a muted call .
To un-mute, tap either of the volume buttons .
•
7

What the lights mean

What you see
What is the mean about your headset
Flashing blue light Flashing every second: active on a call
Flashing blue light
Flashing every three seconds: in standby mode
Flashing red light Running low on battery
Solid red light
Charging
Solid green light Fully charged
Solid blue light In pairing mode – see section 3
5