GreenWorks 21277 Manual De Utilización página 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
OPERATION
INTENDED USE
„ This line trimmer is intended for cutting/trimming grass
and edging in domestic use.
PREPARATIONS BEFORE EVERY USE
„ Always ensure before use that the length of the shaft
is adjusted to a comfortable length to operate the line
trimmer. To change the length of the shaft, unlock the
shaft collar (see figure 8), adjust the height and tighten/
lock the shaft collar again.
„ Ensure that the auxiliary front handle is in a comfortable
position before using your line trimmer. To adjust
the front handle (see figure 5), untighten the handle
adjusting knob, move the handle along the shaft.
Tighten the handle adjusting knob before operating th e
line trimmer.
„ Secure your extension cord using the cord retainer
(figure 6) by looping the extension cord through the
hole in the rear handle and around the cord retainer.
If you bought your line trimmer in the United Kingdom,
please secure the long cord coming out of the line
trimmer in the cord retainer.
„ Before operating the unit, check that the nylon cutting
lines (7) are long enough to touch and pass over the
cut-off blade (10). If they are not long enough you
should press the line release button (17) and pull the
line until it is long enough. Every time you are starting
the line trimmer, the automatic feed line spool also
releases approximately one centimetre of line.
„ Press the button and adjust the lower shaft to the
suitable angle.(fig. 12)
STARTING YOUR LINE TRIMMER
„ Connect the trimmer to the power supply.
„ Hold the line trimmer firmly with both hands so that the
cutting head is slightly above the ground and squeeze
the trigger (1) to start cutting. Make sure that the line
trimmer is not touching grass or debris /stones when
switching it on.
STOPPING YOUR LINE TRIMMER
„ To stop the line trimmer, just release the trigger (1) .
After switching your line trimmer off, the nylon line will
continue to rotate for a few more seconds.
English (original instructions)
CAUTION
GRASS CUTTING TIPS
„ Cut the grass by moving the line trimmer from right to
left, left to right with the line parallel to the ground and
proceeding forward slowly.
„ High grass should be cut in layers, always begin from
the top. The cuts should be short.
„ Do not cut damp or wet grass. Dry grass will give
excellent results.
„ Always let the line rotate at top speed. Do not work in
such a way as to overload the trimmer.
„ Avoid wearing the line out quickly by knocking against
hard objects (stones, walls, fences etc.).
„ Never pass the line trimmer over the electric cable
while the line trimmer is running; make sure the cable
is always in safe position behind your back.
EDGE FUNCTION (Fig.7)
When changing between grass trimming and edging
mode, always make sure that you stop the line trimmer
first and that the cutting lines have stopped rotating.
„ This line trimmer enables you to change between
edging and grass trimming without hassle.
„ Unplug the trimmer. Press the shift button (15) and
rotate the trimmer head 90° then fix the trimmer head.
SAFETY GUARD LINE TRIMMING CUT-OFF BLADE
This trimmer is equipped with a line trimming cut-off blade
on the safety guard. When the line is worn or broken, switch
off the trimmer, after a few seconds switch it on, then the
fresh lines will be released from the spool automatically.
When the lines are long enough they will be trimmed to
optimum length by the cut-off blade. Advance the line
whenever you hear the engine running faster than normal
and when it is apparent the line is worn or broken. This will
maintain best cutting performance.
2
WARNING