Bimar VC82 Manual De Instrucciones página 7

Fax +32 030 9904733
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters) to
avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help.
ASSEMBLY
Attention: the fan can only be used if complete with the support base.
lways unplug the appliance before you assemble.
Attention: a
To assemble it, refer to fig. 1: first screw on the front shell, then the back, and inset the electric cord
through the guide, making sure to lock it with the screws provided.
1) Front shell
2) Attachment screws
3) Electric cord
4) Rear shell
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
Your appliance has the following controls which are accessed by pressing the keypad on the control panel
or on the remote control. The remote control must be pointed towards the upper display after you have
inserted the batteries (open the rear cover and insert two "AAA," taking care to observe their polarity.
Close the cover).
Insert the plug in the wall outlet and proceed as follows:
Turn on the fan by pressing the On/Off key on the remote control or on the control panel.
1) Select the desired speed by repeatedly pressing the "
corresponding to the speed selected:
1 = Minimum speed
2) Oscillation (right - left): press the "
oscillation, press the "
Timer: this sets the operating time and the fan will automatically stop at the end.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
2 = Medium speed 3 = Maximum speed
" key on the remote control or the push button panel. To stop
" again (the indicator will go out).
7 20
/
Assembly page 7/20
5) On/Off switch
6) Oscillation switch
7) Timer switch
8) Breeze switch
9) Speed switch
" key: an indicator will light on the display