Installation Example - Vetus MGS Instrucciones De Instalación

Hose connections
In to order to best connect the hose to the
waterlock, the top portion of the waterlock
can be turned in a 360° radius.
The top portion should be turned as follows:
1 Unscrew the bolts. Do not remove the nuts
from the bolts
2 Pull the top portion of the waterlock
upwards
3 Turn the top portion to the desired posi-
tion
4 Let the top portion down again
5 Tighten the bolts without deforming the
spacer tubes
Fitting the hose
To ease the fitting of the hose to the hose connector, use only
water and/or soap, NOT grease or products containing oil.
Fit each hose connection with 2 stainless steel 12 mm (0.5")
wide hose clamps.
Sensor for temperature alarm
A sensor for a temperature alarm can be fitted in the exhaust
pipe.
A sensor for a temperature alarm can also be fitted in the
exhaust silencer connector. The 'IN' connector on the exhaust
silencer has two circular areas. These are intended for fitting the
temperature sensor. Drill in one of these areas a hole of the cor-
rect size. Fit the sensor with a lock nut and, after fitting, check
that the exhaust silencer is completely liquid and gas-tight.
Waterlock MGS - MGL
1
www.Busse-Yachtshop.de
2
4
Installation example
On p. 15, you will find a depiction of an exhaust system with a
waterlock of type MGS/MGL and a transom exhaust connec-
tion.
When the engine is stopped, any water which is still in the
exhaust pipe (between the highest point in the exhaust system
and the waterlock) will run back to the waterlock.
Maintenance
Check all hose connections for gas and water leaks regularly.
Before the winter lay-up, drain the waterlock. The waterlock has
a drain plug for this purpose.
info@busse-yachtshop.de
ENGLISH
3
5
5
030418.03