Ce Conformity Declaration; Specification; Use With Restricted Frequency Range (France Mode) - Multiplex COCKPIT SX M-LINK Manual De Instrucciones

C SX M-LINK
OCKPIT
4. Model aircraft: place or hold the model in such a
position that the receiving system is about 1 m
above the ground.
Land vehicle or boat: place the model on the
ground or in the water.
Switch the model's power system off!
5. Switch the receiving system on.
Move one control function (e.g. elevator) constantly
and smoothly. This allows you to see clearly whether
the receiving system responds to your control com-
mands with smooth, clearly defined movements of
the corresponding control surface.
6. Increase the distance between the transmitter and
the model.
Note: changing the model's attitude
Constantly move (rotate, tip, incline) the model
during the range check, so that the test does not
apply to one flight attitude only.
You have reached the range limit when the servos
no longer respond distinctly and with constant move-
ment to your control commands.
The following have a marked influence on range ...
... environmental conditions:
Obstacles which detract from the visual link bet-
ween transmitter and model.
The type and quality of the terrain, and the weather.
... receiver technology and sophistication:
Technically sophisticated receivers offer greater
range than simple, small, low-cost receivers.
... conditions inside the model:
Aerial deployment, distance from batteries, motors,
servos, ignition systems, metallic / carbon fibre
parts all have an effect on radio range.
Important: read the receiver instructions
To establish the actual range which should be achieved
with a particular receiver, please refer to the instruct-
tions supplied with that receiver.
The instructions also include important information
regarding the installation and optimisation of the
receiver aerial(s).
Important if the model contains a power system:
Carry out the initial range check with the power system
off, then repeat the check with the motor running
(varying throttle settings): there should be little dif-
ference in the range achieved. If this is not the case,
you need to locate and eliminate the cause of the
interference (the motor itself, the arrangement of the
receiving system components and power supply,
vibration, etc.).
! Notes on optimising the deployment of the re-
ceiver aerial(s), taking into account the LQI value
(LQI = Link Quality Indication), can be found in
Chapter ( 12.5.4.c).
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de

6. CE Conformity Declaration

MULTIPLEX Modellsport GmbH & Co. KG hereby de-
clares that the device described in these instructions
fulfils the requirements of the following harmonised EU
directives:
Electromagnetic Compatibility and Radio Spectrum Matters (ERM)
EN 300 328-1, EN 300 328-2
EN-301 489-1, EN 301 489-17
Safety
EN 60950-1
A detailed CE Conformity Declaration can be found on
the Internet as a PDF file at www.multiplex-rc.de in the
DOWNLOADS area under PRODUCT INFORMATION.

7. Specification

Channel count 7 servo channels
Model memories 18
Transmission 2.4 GHz FHSS M-LINK
method
2.4000 GHz – 2.4835 GHz
Frequency range
Restricted frequency range
2.4000 GHz – 2.4540 GHz
Servo signal format UNI
at 100% servo travel
Signal repeat time 14 ms (Fast Response)
(frame rate) 21 ms
Power supply Battery: 7.2 V, 1800 mAh
6 cells, AA-size, NiMH
Current drain ~ 80 mA incl. RF section
Operating tem-
15 C to + 55 C
perature range
Storage tem-
20°C to + 60°C
perature range
Dimensions Length ~ 190 mm
(hand-held)
Width
Height
Weight ~ 740 g incl. battery
(hand-held)
7.1. Use with restricted frequency
range (France mode)
Before the M-LINK system can be used in particular coun-
tries it is essential to activate the reduced frequency
range permitted in the region concerned (
summary of the countries affected can be found in the
supplementary sheet " Operating the 2.4 GHz M-LINK
System with Restricted Frequency Range
In its default state the C
with France mode switched off (= 0).
This is the procedure for activating restricted frequency
range (France mode switched on (= 1)).
1.5 0.55 ms
(~ 220 mm with aerial
fitted, angled at 90°)
~ 185 mm
~ 60 mm excl. sticks
and carry handle
".
SX M-LINK is supplied
OCKPIT
Page 20
7.). A